This came in over my EV list. Have fun:) > NRGCELLS 2500mAhr Polymer APPROVED CHECKED PREPARED > > Doc. Class PRODUCT SPECIFICATIONS DEP. Technical Division > Doc. Name. SUPERIOR LITHIUM POLYMER BATTERY Pages 1/5 > Doc. No. SLPB456495 Issue April. 14. 2000 > 1. SCOPE This specification is applied to SLPB456495 (Superior Lithium > Polymer Battery) soft pack 2. APPLIED PRODUCT AND PRODUCT NUMBER 2. 1. > NAME ? Superior lithium polymer battery 2. 2. PRODUCT NUMBER ? SLPB456495 > 3. PRODUCT SPECIFICATIONS > No. ITEM RATED PERFORMANCE REMARK > 1 Rated Capacity 2500mAh (Ave.) Rated Discharge1) Capacity After Rated > Charge2). > 2 Rated Voltage 3.7V Mean Operation Voltage During Rated Discharge After > Rated Charge. > 3 Voltage at end of Discharge 3.0V > 4 Maximum Charge Voltage 4.2V > 5 Maximum Continuous Charge Current 2.50A > 6 Maximum Continuous Discharge Current 4.50A > 7 Operation Temperature Range Charge: 0 ~ 45oC 60 25% R.H. > Discharge: -20 ~ 60oC > 8 Storage Temperature Range -20 ~ 40 oC 60 25% R.H. > 9 Weight 53.5 0.5g > 1) Rated Discharge: Constant current discharge (0.2C) till discharge end > voltage (3.0V) at 205 oC. 2) Rated Charge: 4.2V constant > voltage and (0.7C) current limited charge till 22mA charge > current at 205 oC. > Doc. Class PRODUCT SPECIFICATIONS DEP. Technical Division > Doc. Name. SUPERIOR LITHIUM POLYMER BATTERY Pages 2/5 > Doc. No. SLPB456495 Issue April. 14. 2000 > 4. PERFORMANCE AND TEST CONDITION > No. ITEM CRITERIA TESTING CONDITIONS > 1 Outside Appearance No abnormal strain, deformation nor damage Visual > check > 2 External Dimension According to the attached drawing Use caliper (0.05mm > a division) specified in ISO 3599 > 3 Discharge Time More than the rates mentioned hereunder Measure time > elapsed till end discharge voltage at the discharge conditions mentioned > hereunder after rated charge > Discharge Temperature -10 C 25 C 40 C > Discharge Current 500mA 280min. 300min. 300min. > 2500mA 20min. 55min. 55min. > 4 Charge Time More than the rates mentioned hereunder Measure time elapsed > till end charge current at the charge conditions mentioned hereunder after > rated discharge > Charge Temperature 0 C 40 C > Charge Current 1750mA Less than 3.0h Less than 2.5h > 2500mA Less than 2.5h Less than 2.0h > 5 Internal Impedance Less than 30m Measure by alternate current (1kHz) > within 1h after rated charge. (205 oC) > 6 Open Circuit Voltage Above 4.0V Measure within 24h after rated charge. > (205 oC) > 7 Cycle Life (0.2C) Above 210min. Carry out 400cycles rated charges and > rated discharges. (205 oC) Then measure rated discharge time after rated > charge. > 8 Storage Performance (0.2C) Above 260min. Discharge 50% after rated charge > at 205 oC, then leave 30 days. After storage, execute rated discharge and > rated charge then measure discharge time under rated discharge > (Remark) Tests shall be performed on a new cell within one week after > delivery. > Doc. Class PRODUCT SPECIFICATIONS DEP. Technical Division > Doc. Name. SUPERIOR LITHIUM POLYMER BATTERY Pages 3/5 > Doc. No. SLPB456495 Issue April. 14. 2000 > 5. SAFETY TEST > No. ITEM TEST METHOD RESULTS > 1 Vibration Vibrate the pack in triaxial directions each for 90~100min. in > conditions of frequency 10-55 Hz with amplitude 0.8 mm after standard charge > NO EXPLOSION, FIRE or DEFORMATION > 2 Forced Discharge Discharge at a current of 1.0CmA for 2.5h. (If current > stop by safety or passive circuit on the battery, test is finished.) NO > EXPLOSION, or FIRE > 3 External short Each test sample battery is to be short-circuited by > connecting the (+) and (-) terminals of the battery with a minimum length of > 1.3mm2 Cu wire. Batteries are discharged till reach at room temperature and > at 60oC.Tests are to be conducted at room temperature and at 60oC NO > EXPLOSION, or FIRE > 4 Nail Penetration Penetrate 2.5~5mm nail into cell body for 6hs NO > EXPLOSION, or FIRE > 5 Crush Crush between two flat plates. Applied force is about 13kN. NO > EXPLOSION, or FIRE > 6 Over Charge Charge at a current of 0.5CmA to 250%. (If current stop by > safety or passive circuit on the battery, test is finished.) NO EXPLOSION, > or FIRE > > Doc. Class PRODUCT SPECIFICATIONS DEP. Technical Division > Doc. Name. SUPERIOR LITHIUM POLYMER BATTERY Pages 4/5 > Doc. No. SLPB456495 Issue April. 14. 2000 > 6. CHARGE STATE OF BATTERY BEFORE SHIPMENT The battery is charged to > approximate 50 % of rated capacity. 7. HANDLING PRECAUTIONS For use of > this battery, must follow as specified below. Other than conditions listed > may cause major burst, fire, some smokes and it will cause severe > performance failure and unsafe for use. Please be sure to follow > instructions carefully. (1) Use specified charge/discharge conditions. (2) > Specified product use only. (3) Don't short terminals. (4) Don't immerse in > water or pour. (5) Don't heat or throw in fire. (6) Don't leave in > conditions where more than 70? or in heated car. Also don't charge/discharge > in conditions specified. (7) Don't attempt to crush or drop. (8) Don't > attempt to modify. (9) Don't solder. (10) Leave in cool places. (11) Don't > put it in microwave oven, oven or pressure container. (12) If charging time > is longer than specified, stop charge. (13) During assembly, charging, > normal use and storage of battery pack, such as smell, change of color, > mechanical abuse are detected don't use. (14) In case of leakage or smells > remove from thermal conditions. Also wash off with clean natural water for > leaked solvent. (15) In case of solvent in your eye, wash off with clean > natural water and consult your doctor. > Doc. Class PRODUCT SPECIFICATIONS DEP. Technical Division > Doc. Name. SUPERIOR LITHIUM POLYMER BATTERY Pages 5/5 > Doc. No. SLPB456495 Issue April. 14. 2000 > 8. HISTORY OF REVISION > CONTENT OF AMENDMENT > REV.ISSUECURRENTNEWAPP.CHK.PRE.0100.04.12.- - - - -1st EDITION02 -- | Bryan Andersen || http://www.nerdvest.com | | Buzzwords are like annoying little flies that deserve to be swatted. | | -Bryan Andersen | -- Subscription/unsubscription/info requests: send e-mail with subject of "subscribe", "unsubscribe", or "info" to
Wear-Hard Mailing List Archive (searchable): http://wearables.blu.org please, Please, *PLEASE* don't subscribe through a forward/false domain
From Wear-Hard Mailing list Archive (WH)
Maintained by R. Paul McCarty
Archive created with babymail