Hey- I bought one of these things about 6 mo's to a year ago, even if I did lose the tiny thing :) . I still have the documentation, however... --- V & H driver supply voltages: -1v to +17v video signal input pin voltages: -1v to +15v Supply voltage: 13.5±0.5v input pin voltage 2.8v Pins --- 1)Common voltage of panel 2)G video 3)R video 4)B video 5)not connected (no pin--kind of makes the connector "keyed") 6)Clock pulse for H shift register drive 7) " " " " " " 8)Start pulse for H shift register drive 9)Drive direction for H shift register (H-normal, L-reverse) 10)improvement pulse for uniformity 11)Enable pulse for gate selection 12)Clock pulse for V shift register drive 13) " " " " " " 14)Start pulse for V shift register drive 15)GND for the H & V drivers 16)H & V driver power supply The problem, however, is getting the darn thing connected. The "pins" are exposed traces on the flexible, plastic-ish tft tail, which is about 1-1.5 cm wide, so the pins are really small. Hope this is useful, --Moophus -- Subcription/unsubscription/info requests: send e-mail with subject of "subscribe", "unsubscribe", or "info" toWear-Hard Mailing List Archive (searchable): http://wearables.blu.org
From Wear-Hard Mailing list Archive (WH)
Maintained by R. Paul McCarty
Archive created with babymail