Hi... I'm new to this list and was wondering if anyone could give me some advise. Below is my current system running off of a heavy lead NiCad 12V battery. <Only for about 2hours but works> I was wondering if anyone had any suggestions on a small light replacement. I was going to use one or two Sony NP-F750s but I'm a software person and volts and watts are confusing to me. The power requirments for the Parvus Power I is 7.5-17V input. I am assuming this would put using a single NP-F750 (7.2V) right out. But could two be used somehow? Does anyone know what would be required to run the following? Parvus Scalable I 486 100mhz w/4mg 72meg DOC Parvus Power I Twiddler M1 - Powered by a NP-F750 Already. Thanks for your help in advance... -Blair -- Subcription/unsubscription/info requests: send e-mail with subject of "subscribe", "unsubscribe", or "info" toWear-Hard Mailing List Archive (searchable): http://wearables.blu.org
From Wear-Hard Mailing list Archive (WH)
Maintained by R. Paul McCarty
Archive created with babymail